![]() ![]() Additional DIY CA hinges will give you more rigid and agile control.Plate integrated inside the fuselage for an additional improvement.Decent back bay for ESC, isolate interference from other FPV equipment.Large battery bay for extended flight time and more parts for various flight controllers.The specially designed "integrated servo arm" structure will protect your servo arm from impact.High precision ball linkage control system brings agile and quick response in control.The CF rod integrated into the fins will give precision and crisp action to your inputs.- Removable main wing and wing tip, glue-free assembly, portable for outdoor flight.Several tunnels inside all the equipment bays, easy to install the wire between each bay.Nasal camera slot compatible with all HD cameras (for Gopro, DJI, Runcam, etc.) on the market.Additional front and side camera bay and main hatch compatible with all FPV and AIO cameras on the market.Molded with tough EPP material, built-in CF spar for enhancement, super stable flight ability and impact resistance.Aerodynamic FPV pocket on both sides of the fuselage, with highly efficient NACA air cooling system to ensure the operation of FPV gears in perfect condition.The world's first FPV wing with dedicated front camera bay and main hatch bay for the DJI HD air unit system, no need to cut or tinker to fit the DJI system. ![]() All in all this is a well planned out bird that should provide hrs of fpv fun. one is made for the Dji fpv system and like the Ar900 has a outer location for another camera, it's just on the left side of the fuse. Comes with x2 nose pieces for your choice of video system. This bird has enough space for a dual video system as it has 2 pockets on each wing half, and 2 more inner pockets on the fuse, plenty of room and separation. If your planing on installing your fc in the rear bay you will need to swap out the stock esc, it's big, and the gps housing is directly above it keep this in mind when mapping out electronics. This unit came with a legit sunnysky motor, 40a SM esc, and some metal gear servo's which appear to be in the 9-12g range. You can have this bird assembled in about and hour or so, but if your adding in a Fc then you'll be on the bench for a couple more hours. I got the unit with power system as it was the only one available. I must say assembly is super simple and the plans could be better as ever step is not shown so some guessing is needed. Ok, so this just showed up, shipping was some what on time took a few days over a week. This is not a first timer wing unless you install a copilot system!! Even with a 4200 4S pack weight is still needed to hit cg keep this in mind also as the only place to shave weight is remove the stock set up or just the esc!! ![]() ![]()
0 Comments
Leave a Reply. |